Monday, May 05, 2014

ETH002 - 2 relay outputs at 16A

ETH002 - 2 relay outputs at 16A 

The ETH002 provides two volt free contact relay outputs with a current rating of up to 16Amp each. The module is powered from a 12vdc supply which can be regulated or unregulated. The DC input jack is 2.1mm with positive core polarity, DC supplies are required to supply at least 500mA at 12vdc. The relays are SPCO (Single Pole Change Over) types. The normally open, normally closed and common pins are all available on the screw terminals. The ETH002 is fully compatible with the ETH-RLY02 and includes the legacy ETH-RLY02 command set.  
The ETH002 has additional features over the ETH-RLY02:
1. Full Factory Reset, all ETH002 firmware and settings can be reset to the original state. 
2. Firmware updates, firmware in the ETH002 is fully updateable by re-flashing the board with our custom windows program. This will be made available in the event of feature updates. 
3. New Command Format, the new command format allows for consistent compatibility with future boards. New commands now allow for pulsed control of relays from 100mS to 25.5 seconds. 
4. TCP/IP Password Protection, it is now possible to set a password for TCP/IP protection. This is independent of the configuration password. 



Operating Temperature
-40C to +70C


LED Indication
The ETH002 provides a red LED mounted immediately next to each relay to indicate whether it is in a powered state (LED on), there is also two LED's mounted in the Ethernet connector which will flash with Ethernet traffic. Finally there is green power LED just above the processor.


Relay Power Rating
If the contact load voltage and current of the relay are in the region enclosed by the solid and dotted lines in the figure below, the relay can perform stable switching operation. If the relay is used at a voltage or current exceeding this region, the life of the contacts may be significantly shortened.


 load type  Typical applications  Rating Max DC load capacity
 AC1 Non inductive or
 slightly inductive loads 
 16A @ 250V AC 
 AC15 Control of
 electromagnetic load
 (>72VA)
 3A @ 120V AC
 1.5A @ 240V AC 
 AC3 Control of motor  750W
 DC1 Non inductive or
 slightly inductive loads
 16A @ 24V DC 
 DC13 Control of electromagnetic
 loads
 0.22A @ 120V DC
 0.1A @ 250V DC