Tuesday, March 01, 2011

CONVERTER USB TO UART

CONVERTER USB TO UART is a converter module USB to RS-232 or USB to RS-485 supports full duplex data rate up to 500 kbps. Power supply module can be taken from the track USB (bus powered) or external 5 VDC power. In this module available LED indicators for power supply, data transmission, data reception and validity of the RS-232 signals. In USB mode to RS-232 is available 9 RS-232 signals (DCD, RX, TX, DTR, DSR, RTS, CTS and RI).

Specifications:
* Dimension : 7 cm (L) x 6 cm (W) x 1.8 cm (H)
* There are 2 options 2-way conversion (can not be shared).
o USB to RS-232.
o USB to RS-485.
* Data rates supported up to 500 kbps.
* Interface with the computer via the USB connector type B.
* Available DB-9 male connector for RS-232 interface.
* This module provides signal DCD, RX, TX, DTR, DSR, RTS, CTS and RI for RS-232 interface.
* The module is functioning as a DTE (Data Terminal Equipment) on the mode of USB to RS-232.
* Available RJ-45 connectors for RS-485 bus.
* Available configuration jumpers for termination resistors on the RS-485 interface.
* Admission data on RS-485 communication & auto power-down feature is not active if the USB in suspend state.
* When auto power down active RS-232, RS-232 driver is active if there is a valid signal on the DB-9 connector.
* Available LED indicators for power supply, receipt & delivery of data and the validity of the RS-232 signals.
* Power supply 5 VDC, can be taken from the track USB (bus powered) or DC jack (external power 5 VDC).
* Selection of the power supply source via configuration jumpers.
* Available for USB drivers.
* Equipped with a datasheet, manual, test procedures, schematics and test programs.

Equipment:

* 1 unit of DT-board I / O CONVERTER USB TO UART.
* 1 set USB cable (p = ± 150 cm).
* CD / DVD-ROM containing manual, datasheet, test procedures, schematics, test programs and websites Innovative Electronics and USB drivers